Skip to main content
The SambaRack SN40L-16 rack networking devices are preconfigured during installation. In some cases, administrators may need to perform limited post-installation administrative tasks, as described in this document. For additional details, refer to the Third-party component documentation.
The Juniper QFX5130 port 16 will show an amber light. This is expected behavior and not a warning condition.

​
Password administration

SambaRack and Core Services Racks ship with default usernames and passwords for all devices. Please see SambaNova support KB article #1411 for the default credentials. Administrators are strongly advised to change these at the first opportunity.
SambaRack Manager must always be updated with the latest device credentials.

​
Juniper EX series access switch and QFX5130 data switch

​
Step 1: Connect and configure the new password

Run the following commands:

​
Step 2: Log out

Log out of the switch by using the exit command three times:
  1. To exit config mode
  2. To exit operational mode
  3. To exit the Linux CLI

​
Step 3: Verify the new password

Log back into the switch with the new password to confirm the change was successful.

​
Step 4: Update SambaRack Manager password vault

If SambaRack Manager is installed and set up, it must be updated with the latest credentials to ensure proper operations. See the Set Secret section for more details.

​
Lantronix SLC8000 serial console server

​
Step 1: Connect and configure the new password

Run the following commands:

​
Step 2: Verify the new password

Log back into the console server with the new password to confirm the change was successful.

​
Step 3: Update SambaRack Manager password vault

If SambaRack Manager is installed and set up, it must be updated with the latest credentials to ensure proper operations. See the Set Secret section for more details.

​
Patching network devices

SambaNova provides a periodic patch release for network devices. See KB article #1062 “Listing and downloading available SN40L rack firmware” for details. Patch update release notes explain any variations from the processes provided in Third-party component documentation.